Schlage PIB300 User Manual page 391

Erasing HandReader Memory
Erasing the
HandReader
Setup
Erasing the
HandReader
Setup and User
Database
!
NOTE
The erase memory function allows a Hand Reader's setup and/or user database to be
erased. The factory default setting (and normal operation setting) is for switches 4 and 5
to be OFF, retaining memory.
Perform the following steps to erase the setup programs but retain the user database.
1. With system power OFF, set switch 4 ON.
2. Turn system power ON and wait 5 seconds.
3. Turn switch 4 OFF.
Perform the following steps to erase both the setup programs and the user database.
1. With system power OFF, set both switches 4 and 5 ON.
2. Turn system power ON and wait 5 seconds.
3. Turn both switches 4 and 5 OFF.
Before putting the hand reader into service ensure DIP switches 4 and 5 are both OFF. If
switches 4 and 5 are not off, the next time the Hand Reader's power is cycled the Hand
Reader's memory will be erased.
HandKey II Manual
75