Schlage PIB300 User Manual page 951

Configuration Tab
Connecting through a TCP/IP network
To connect to a site through the network,
you must have a TCP/IP network with
static IP addresses. Your computer
must have a network card and be
connected to the network. If the network
is faster than 10baseT, you must have a
switching hub. To use TCP/IP, you must
have either ordered readers with the
Ethernet option enabled or purchased
an Ethernet upgrade.
Table 10.1: TCP/IP Network Fields
Field Req'd?
Network Name Yes
Description No
Enabled No
Delete This Network No
Network Type Yes
IP address Yes
22 • Schlage • HandNet Lite Terminal User's Guide
Figure 10.2: Edit a TCP/IP Network
Description
• Name of the network
• Any combination of letters, numbers, spaces, and special characters, up to 30 characters
long
• Brief description of the network
• Must be checked for HandNet Lite to communicate with the network and monitor any
readers connected to it.
• Generally you would only uncheck this if you were in the process of setting up or
reconfiguring the network and didn't want the program to try to communicate
• Having the Enabled box checked if the network isn't really connected to HandNet Lite
causes the program to slow down significantly. Make sure that this is only checked if the
network is actually set up and connected
• Check to delete this network and remove it from the Schlage Biometrics network selection
list. If there are no readers in the network, it will be deleted when you click Accept settings.
• You can't delete a network with readers on it
• Choose Serial port or TCP/IP
• The remaining fields will be determined by this selection.
• Only available if TCP/IP was chosen in the Network type field.
• The IP address (xxx.xxx.xxx.xxx) of the reader
• Must match the IP address set in the reader. See the reader manual for more information
• Ask your network administrator for an appropriate address