Schlage PIB300 User Manual page 1250

Programming the HandPunch
System Management
28
Once a HandPunch system is in operation the following commands are used for system
management.
List Users – List the Users authorized to use a HandPunch. This is done through the
Management Menu. The instructions for listing employees begin on page page 35.
Set User Data – Set a user's reject threshold (adjusting the sensitivity applied when
a HandPunch reads a hand) this task is done through the Management Menu.
The instructions for setting user data begin on page page 35.
Remove User – Remove employees (and supervisors) from a HandPunch. This is done
through the Enrollment Menu. The instructions for removing employees begin on
page page 39