Schlage PIB300 User Manual page 1013

Programming the HandPunch
Calibrate
Status Display
28
The Calibrate command displays the HandPunch's exposure values, allowing you to verify
these values are within normal operating parameters. The standard operating parameters
are shown in Table 5
.
Table 5: Normal Operating Parameters
Parameter
Row "r"
Column "c"
Exposure "e"
The status display command allow you to enable or disable the displaying of the following
information.
• the status values of HandPunch inputs and outputs
• the hand read score of the last user to verify on the system
When the status display is enabled, Figure 8-1 identifies each status display field value
- ENTER ID
O C O C O H L H L NN
O C O C O H L H L NN
O = Circuit Open
C = Circuit Closed
Figure 8-1: Status Display Chart
Normal Range
0 +/- 2
0 +/- 2
100 +/- 20
-
Last Hand Read Score
Aux Out 2
Aux Out 1
* Aux Out 0
* Lock
Aux In 2
Request to Exit
Aux In 1
Door Monitor Switch
Tamper
* These status values are inactive if the
reader is in Card Reader Output Mode.
H = Output is OFF (High)
L = Output is ON (Low)
These Input/Output
values do not apply to
the HandPunch 1000
.