Schlage PIB300 User Manual page 343

WALL TO WHICH
THE HAND READER
IS ATTACHED
12 to 24 V
AC/DC Input
1 2
Connection
* These components are not supplied by Recognition Systems, Inc.
!
NOTE
All HandReaders in a network must be set to the same communication method. Four-wire
RS-422 cabling is required for HandNet for Windows™ network installations. Schlage
Biometrics does not recommend two-wire RS-485 cabling for new network installations.
*Serial Printer
14 13 12 11 10 9
18 17 16 15
RS-422
TOP OF THE
HAND READER
HINGE
8 7 6 5 4 3 2 1
J4
RS-232 Jack
Figure 7-7: Printer to HandKey CR Wiring Diagram
HandKey II Manual
HINGE
4 Pin
Connector
27