Schlage PIB300 User Manual page 606

d. Wall Mount: Use the bracket as a template to mark the two mounting holes. Mount to
the wall using screws, and wall anchors if necessary (not provided). Fully tighten the
loose screws and nuts (steps b and c). Tighten all mounting bracket screws at a
torque of 30 inch lbs.
Pole Mount: Attach the
pole brackets to the pole
as shown. Secure the pole
brackets with two 5-inch
screws, a washer and a
helical spring lock washer
on each side. Adjust to
the desired angle. Fully
tighten the loose screws
(steps b and c). Tighten
all mounting bracket
screws at a torque of 2.5
ft-lbf (3.4 N-m).
Test to verify that the antenna has been correctly installed:
If you encounter problems while performing the following tests, refer to the
L
Troubleshooting section in this guide and/or within the applicable WAPM user
guide.
1. Place the PIM400 into link mode. Refer to the PIM400-485 User Guide or the PIM400-
TD2 User Guide, in "Link Mode" section.
2. Place the WAPM into link mode. Refer to the AD400/AD401 or WRI400 User Guide, in
"Link to a PIM400" section.
3. Verify that the WAPM links successfully with the PIM400. Refer to the label located
inside the PIM400 enclosure for LED blink patterns that indicate successful linking.
Minimum diameter 1" (25 mm)
Maximum diameter 4C|v" (120 mm)
Pole mount shown
Testing
13