Schlage PIB300 User Manual page 657

Installing the FingerKey
8
4. Connect the wiring to the reader.
Power Connection
Make sure the wire
bundles don't press
against the rest or
cold boot switches.
• Wiring instructions begin on page 9.
• Make sure you position the wire bundles so they don't accidentally press the
reset and cold boot buttons when you close the reader. It would cause problems if
the wires kept these buttons pressed when the reader was closed.
5. Hook the top of the reader on to the clips on the mounting plate, push the bottom of
the reader in, and then insert the torx screw that holds the bottom of the reader to the
mounting plate.
• In cold weather: Remember that all plastics are brittle when cold. If, for example,
you've left the reader in your truck overnight on a cold winter night, you should let
the reader warm up to room temperature before installing it. (If you don't, and if
you overtighten the torx screw, you could crack the plastic around the hole.)
Terminals 1-12 for
reader wiring
connections