Schlage PIB300 User Manual page 393

Appendix D: Troubleshooting Guide
Display
Messages
During
Verification
Various messages can appear on the HandPunch's display during hand verification.
These messages are defined in.
Table 20-17: Display Messages During Verification
Message Definition
PLACE HAND The platen is ready to receive your hand for verification.
ID VERIFIED You are verified, proceed.
REMOVE HAND Remove your hand and place it on the platen again. Follow proper
hand placement rules.
TRY AGAIN Your attempt was rejected. Repeat verification following proper
hand placement rules.
ID REFUSED Your rejections exceeded the maximum number of tries allowed.
Wait until another employee has verified and try again or call your
supervisor.
ENTER ID You entered your ID number incorrectly or your access time is
restricted.
• If the display shows TRY AGAIN, you are not verified. You may have made an error
in entering your ID number or in placing your hand on the platen. Re-enter your ID
number and try again, taking care to follow proper hand placement rules (see page
60).
• If the display shows TIME RESTRICTION, you are not authorized to punch in at this
time. If this seems to be in error, contact your supervisor about time restrictions.
• After a pre-programmed number of denied attempts, an ID number will no longer be
accepted and the display will appear as follows.
This is called a "lockout." Before the rejected ID number can be used again, another
employee or a supervisor must successfully verify at the HandPunch.
• If you enter your ID number, but do not place your hand on the platen, the HandPunch
will time-out in about 25 seconds. You can immediately end this time-out by pressing
the key.
Clear
ID INVALID
TEMPORARILY
77