Schlage PIB300 User Manual page 794

Introduction
Hardware Connection
Prior to making facility changes in Schlage Express or programming a lock, your hardware must be connected properly. Connect
hardware as shown below.
From PC to HHD
Use the standard HHD USB cable (HH-USB) to connect the HHD to the PC.
From HHD to USB enabled Lock (AD, CO or CT series)
Use the standard HHD USB cable (HH-USB) to connect the HHD to USB enabled lock.
From HHD to non-USB enabled Lock
Use the HHD Serial cable (HH-SERIAL) to connect the HHD to the CIP then connect the CIP to the Lock.
Î NOTE: Regardless of lock model, smaller circle on CIP always plugs into smaller circle on iButton receptacle of lock being
programmed.
Schlage • Schlage Express Software Manual • 7