Schlage PIB300 User Manual page 337

Wiring Connections
Wiring Examples
Once the HandReader is attached to the wall plate the wiring connections to the
HandReader can be made (see Figure 5-1).
WALL
Power
Connectors
The following Tables provide the pin outs for the terminal strips on the HandReader.
• Table 2 on page 22 provides the pin outs for TS-1: Communication Connections.
• Table 3 on page 22 provides the pin outs for TS-3: Output Connections.
• Table 4 on page 22 provides the pin outs for the Serial RS-232 Connection.
The following Figures provide typical HandReader wiring diagrams.
• Figure 5-2 on page 22 provides a typical Output wiring diagram.
• Figure 5-3 on page 23 provides a typical Card Reader Emulation Mode wiring diagram.
• Figure 5-4 on page 24 provides a typical RS-422 Master/Remote Network System wiring
diagram.
• Figure 5-5 on page 25 provides a typical RS-485 2-Wire Master/Remote Network
System wiring diagram.
• Figure 5-6 on page 26 provides a typical Host PC Network System wiring diagram.
• Figure 5-7 on page 27 provides a typical Printer to HandReader wiring diagram.
Not
J7 Battery
Reset
Used
Jumper
Switch
Terminal
Optional Modem
Strips
or Ethernet
Top of HandKey
Wall Plate
Top of
Serial RS-232
Terminal
Figure 7-1: Wiring Connections
21