Changing The Reader Address - Schlage PIB300 User Manual

Changing the
Reader Address
You must set the address in readers that are connected to the computer by
a serial cable, and in readers that are connected to another reader (that is,
readers that are not the first reader in the site). You cannot change the address
in a reader that has an ethernet card; these readers automatically have an
address of zero (0).
The following steps are specific to the HandKey II and CR; the menus are
slightly different in other readers. Please see the manual that came with the
reader if you are not sure how to find the correspond settings in your reader.
1. If you have not already done so, follow the steps on page 54 for getting to the
reader setup menu.
2. Press the * / NO button until the display looks like this:
SET ADDRESS
3. Press the # / YES button. The display will look like this:
4. Type the new address. The address you enter must match the address on
the General tab in Reader Properties; see page 45. Press YES or ENTER.
The display returns to:
5. If you are done changing settings, press CLEAR to leave the Reader
Command menu. If you need to change others settings, press NO until you
get to the next setting you need to change.
* NO YES #
RDR ADD ID 1
NEW?:
SET ADDRESS
* NO YES #
HandNet for Windows
55