Changing The Serial Settings And Baud Rate - Schlage PIB300 User Manual

Hide thumbs Also See for PIB300:

Table of Contents

Setting Up Sites and Readers

Changing the

Serial Settings

and Baud Rate

You must have appropriate serial settings and baud rate in readers that are

connected to the computer by a serial cable, and in readers that are connected

to another reader (that is, readers that are not the first reader in the site). These

settings do not apply to a reader with an ethernet card.

The following steps are specific to the HandKey II and CR; the menus are

slightly different in other readers. Please see the manual that came with the

reader if you are not sure how to find the correspond settings in your reader.

1. If you have not already done so, follow the steps on page 54 for getting to the

reader setup menu.

2. Press the NO button until the display looks like this:

3. Press the YES button. The display will look like this:

SET RS-485/422?

4. Typically you will answer YES here. The display now asks for the baud

rate. The baud rate here must match the rate on the Connection tab in Site

Properties. Generally 9600 is appropriate.

If you have a HandKey II or HandKey CR:

The display will show the baud rate:

To accept the rate shown and continue, press YES. To change the rate,

press NO to cycle through the choices until you find the one you want.

If you have an ID3D HandKey: The baud rate is represented by a code:

For example, for 9600, you would enter the code of two (2).

5. The reader will display:

SET RS-485/422?

Show Quick Links

Chapters

Table of Contents