Schlage PIB300 User Manual page 1054

The relevant keys should be typed in HEX format (0 – 9, A – F) on
position 2 and 3. The first key is the "A" key for reading information
the second the "B" key for writing information to the card. The field
in the middle is the access conditions for the sector. For our
purpose: Key Upload they are not relevant.
As an example the keys "111111111111" are typed as key A for
sector 2 and "222222222222" as key B for sector 2.
"333333333333" key A to sector 3 and "444444444444" as key B for
sector 3.
When the keys are defined, the new key set can be stored on a
floppy disk with File, Save As. Store the keys in a secure place!
Step III
The Key Set with the relevant keys for sector 2 and 3 need to be
transported to the HandReader, this is done by means of the project
specific Project Card. Put the Project Card on the IOLAN Desktop
Reader. and choose option Card, Save To Card the key
background will light up green and the key set is stored.
Step IV
Present the Project Card to the powered up HandReader, the card will be recognized by the IOLAN reader and
the keys will be uploaded to the MIFARE module. A beep and Yellow LED can be heard and seen after a
successful upload.
The key upload process can be repeated indefinitely with different keys.
Step V
The user cards for the project should have the right keys for this project on sectors 2 and 3. The access
conditions for sector 2 and 3 should allow read with key A and write with key B. See the Smart Encoder manual
for instructions. For example the settings "78778800" will work with this application.