Schlage PIB300 User Manual page 830

Settings
Mag Card Template
A mag card that is used for access
control is encoded with characters.
Only 16 of these characters can be
used by the system. Some of these
characters may be set to be the
same for all users within a facility
and some of the characters are
unique for each user. Only the
unique characters are used for
verification. The Mag Card Template
is used to specify which characters
should be used for verification.
In the example, the data in the Full
Card Data (No Template applied)
box shows that the card has been
encoded with a facility code, which is
separated from the rest of the data
by an equal sign (=). The first ten
(10) positions have been specified in
the mag card template.
The templated card data shows only
the first ten (10) characters of the
mag card data. The last five (5)digits
do not need to be read by the
system because they will be
encoded to be the same for all cards in the facility. Using this technique, all cards from a particular facility can be easily identified
by a system operator.
The two numbers in the Update Data box show the numbers in positions nine (9) and ten (10). This position is specified in the 1st
Lost Card Update Character box. The update data is used for auto card replacement.
Edit the Mag Card Template
1. Click Settings > Mag Card Template.
2. Click to select/deselect the positions to
be used for the template.
3. Choose the 1st Lost Card Update
Character from the drop-down list.
Î Note: This position and the one
immediately following it will be used
for Auto Card Replacement (ACR).
Schlage • Schlage Express Software Manual • 43