Schlage PIB300 User Manual page 666

Changing
a User's
Authority Level
After you have changed authority levels and left the Security menu, you need an authority
level of 5 to reenter the Security menu. You must have added a user before you can
change that user's authority level.
1. On the reader keypad, press Clear and then quickly press ENTER.
You should see:
If you don't see this, try again. This won't work if you press Clear and ENTER at the
same time; you must press Clear and then press ENTER immediately afterwards. It
also doesn't work if you wait too long between pressing Clear and ENTER; after you
press Clear, you must press ENTER immediately.
2. Type your user ID and press enter.
3. Place your finger when the reader asks you to. After you do this, you see:
4. Type the Security menu password and press enter.
This password is initially set to 5. If you changed this password (see page 51), enter
your password. You'll see:
If the reader shows the Ready display instead of this, either you entered the
password incorrectly or you don't have the authority level to use this menu.
5. Press enter to indicate that you want to set user data. You'll see:
6. Press enter to indicate that you want to set a user's authority level. You'll see:
7. Type the ID number for the user to set the authority level for and press enter. You'll
see:
The user's current authority level is shown on top. (The display above reflects a
current authority level of 0 (zero)).
If the reader flashes Process Fail and returns you to the Set User Authority display,
you entered an ID number for a user you haven't added yet. Make sure you typed the
ID correctly.
ENTER ID
ENTER PASSWORD
SET USER DATA
*BACK #NEXT
SET USER
AUTHORITY
*BACK #NEXT
ENTER ID
0
ENTER NEW VALUE
HandKey II Manual
17