Schlage PIB300 User Manual page 260

Programming the HandPunch
Setup Menu
The Setup menu commands allow you to set the basic operating parameters
for the HandPunch unit. The following section provides a brief summary of all
the parameters that may be set on a HandPunch unit.
Once in the Command Menu, you can step through and set the parameters
NOTE
for each command sequentially. You do not have to exit command mode after
setting any individual command.
Navigating
Enter the appropriate password to enter the Setup command menu. Once
the Setup
you have entered the command menu, there are three options available for
Command
navigating the command menu system.
Menu
•
•
•
Setup
There are six commands available from the Setup command menu:
Commands
•
•
•
•
•
•
•
Refer to "Table 9" on page 57 and identify the command you need to perform.
Step through all previous commands until you reach the desired command.
56
#
Press to enter the command shown on the display.
*
Press to step to the next command in the menu.
Press CLEAR to exit the command menu (pressing any numeric key
also exits the command menu). If you are in a command's sub-menu, press
CLEAR multiple times to completely exit the command menu.
Set Language
Set Date Format
Set Date and Time
Set Address
Set ID Length
Set Serial
Set Output Mode