Schlage PIB300 User Manual page 379

Hide thumbs Also See for PIB300:

Table of Contents

Appendix C: Old Board Configuration

Wall Plate Installation

Attaching the

1. Loosen the three bottom mounting screws until there is approximately 1/8 inch (3

mm) clearance between the screw head and the wall plate.

2. Remove the HandReader from its carton.

3. At the base of the HandReader is a piano hinge with three keyhole shaped slots that

correspond with the three lower mounting screws. Align and hang the HandReader

from the three lower mounting screws (see Figure 17-1).

2 UPPER SCREWS

5. Tighten all three lower mounting screws.

6. The Hand Reader is now ready for its wiring connections.

REAR OF TERMINAL

Figure 19-4: Attaching the Hand Reader to the Wall Plate

Show Quick Links

Chapters

Table of Contents