Schlage PIB300 User Manual page 961

Configuration Tab
Figure 10.9: The Card Format Screen
The appearance of this screen varies depending on what you choose. The width of the Bit Map section changes based on the
length you define for the ID. The Parity sections at the bottom only appear if you indicate that there are parity bits
Table 10.7: Card Format Fields
Field Req'd?
Name Yes
Format Number Yes
Length in Bits Yes
No of Parity Bits No
Bit Map Yes
Delete No
Bits Direction Yes
Clone From No
Input Restriction Yes
Digital Format Yes
32 • Schlage • HandNet Lite Terminal User's Guide
Description
• Name that clearly identifies the format
• Internally generated number to identify the format. Cannot be changed.
• Number of bits in the format. This is the total number of bits, not just the number of bits in the
ID
• If there are any parity bits, enter the number (1-4) here.
• For each parity bit specified here, a Parity section appears below
• Structure of the format and how each bit is used.
• To change how different bits are used, see
Figure 10.10: Bit Map Example
• Deletes the current format.
• Forward: bits will be read in from left to right
• Reverse: bits will be read in from right to left
• Only appears if you are creating a new format.
• Allows you to make a copy of an existing format.
• Entries on the screen will be set to match the settings for the format you choose.
• Yes: only an exact format match will be accepted. Gives higher security since cards that are
not issued by you will not be accepted.
• No: any input and parses will be accepted
• Leave this set to Binary unless you understand what BCD is and have a specific reason for
choosing it
Card Format Structure
on page 33 for more information.
on page 33 and