Schlage PIB300 User Manual page 815

Setting Up the Site/Quick Start
Assigning a Programming iButton Electronic Deadbolts
This section covers how to assign a programming ibutton to both Legacy KC2 Locks and to the BE367 Schlage Programmable
Electronic Deadbolt.
BE367 Schlage Programmable Electronic Deadbolt
A red programming iButton enables you to set a lock into programming mode. BE367 locks direct from the factory do not initially
accept the Programming iButton. You can assign a Programming iButton to each BE367 lock by the following steps.
1. At any BE367 lock, press a red programming iButton to the BE367 lock's iButton receptacle. The indicator light flashes green
and red.
2. While the indicator is flashing the BE367 is in programming mode.
3. Connect the CIP to the BE367. The lock can now be programmed.
Legacy KC2
A programming iButton enables you to set a lock into programming mode. Legacy KC2 locks direct from the factory do not initially
accept the Programming iButton. You can assign a Programming iButton to each Legacy KC2 lock by the following steps.
1. At any Legacy KC2 lock, enter the factory default programming code: 9 7 5 3 1 * The factory default code sets the KC2 lock
into programming mode.
2. When the flashing stops, enter the code: 7 *
3. Press a programming iButton to the KC2 lock's iButton receptacle. The indicator light flashes green and red.
4. When the flashing stops, remove the iButton. The KC2 lock will now accept the iButton for programming.
• The factory default code will no longer be valid.
• All KC2 locks will accept a Black iButton as a programming key. You can only use a Red iButton to program a KC2
Deadbolt.
28 • Schlage • Schlage Express Software Manual