Subnet Mask - Schlage PIB300 User Manual

For this Enter this for

subnet mask:

the host bits:
255.255.255.255
255.255.255.254
255.255.255.252
255.255.255.248
255.255.255.240
255.255.255.224
255.255.255.192
255.255.255.128
255.255.255.0
255.255.254.0
255.255.252.0
255.255.248.0
255.255.240.0
7. The reader will display:
The speed you choose should match the baud rate you are setting in the
rest of the readers in this site. Generally 9600 is appropriate. To accept the
rate shown and continue, press YES. To change the rate, press NO to cycle
through the choices until you find the one you want.
Once you press YES, the reader display returns to:
8. If you missed one of the settings because the reader display changed too
quickly for you, press YES to go through the settings again. If you are done
changing settings, press CLEAR to leave the command menus.
9. If you need the changes to take effect immediately, disconnect the power
from the reader, wait a few seconds, and then connect the power again. This
resets the reader. If you do not do this, it may take up to six minutes for the
changes to take effect.
* * * * *
subnet mask:
0 255.255.224.0
1 255.255.192.0
2 255.255.128.0
3 255.255.0.0
4 255.254.0.0
5 255.252.0.0
6 255.248.0.0
7 255.240.0.0
8 255.224.0.0
9 255.192.0.0
10 255.128.0.0
11
12
9600 BAUD
* NO YES #
SET SERIAL
* NO YES #
HandNet for Windows
For this Enter this for
the host bits:
255.0.0.0
13
14
15
16
17
18
19
20
21
22
23
24
59