Schlage PIB300 User Manual page 382

Appendix C: Old Board Configuration Information
Wiring
Examples
66
The following Tables provide the pin outs for the terminal strips on the Hand Reader.
• Table 13 provides the pin outs for TS-1: Power and Communication Connections.
• Table 14 provides the pin outs for TS-3: Card Reader and Output Connections.
• Table 15 provides the pin outs for the RJ-45 Serial RS-232 Connection.
The following Figures provide typical Hand Reader wiring diagrams.
• Figure 17-3 on page 65 provides connection points for ground
• Figure 17-4 on page 67 provides a typical Output wiring diagram.
• Figure 17-5 on page 68 provides a typical Card Reader Emulation Mode wiring diagram.
• Figure 17-6 on page 69 provides a typical RS-422 Master/Remote Network System
wiring diagram.
• Figure 17-7 on page 70 provides a typical RS-485 2-Wire Master/Remote Network
System wiring diagram.
• Figure 17-8 on page 71 provides a typical Host PC Network System wiring diagram.
• Figure 17-9 on page 72 provides a typical Printer to Hand Reader wiring diagram.
Table 19-14: TS-1 - Power and Communication Connections
Terminal Connection
1 Power Input 12 to 24 VDC/VAC
2 Power Return
3 RS-422 Rx- or RS-485 Rx-/Tx-
4 RS-422 Tx- or RS-485 Rx+/Tx+
5 RS-422 Rx+
6 RS-422 Tx+
Table 19-15: TS-3 - Card Reader and Output Connections
Terminal Connection
15 +5 VDC @ 400 mA Max. Output for External Card Reader
16 Card Reader: Wiegand D0 or Magstripe Data Input
17 Card Reader: Wiegand D1 or Magstripe Clock Input
18 Card Reader Ground
19 Wiegand D1 or Magstripe Clock Output
20 Ground
21 Wiegand D0 or Magstripe Data Output
22 Ground
23 Auxiliary Output 1
24 Ground
25 Auxiliary Output 2
26 Ground