Schlage PIB300 User Manual page 958

Configuration Tab
Fingerprint Settings Screen
The Fingerprint Settings screen controls
a number of the reader's internal
settings.
Edit Fingerprint Settings
1. Click the Configuration tab.
2. Select the network in which the
reader you want to edit exists in the
network drop-down box.
3. Select the reader you want to edit
from the reader drop-down box.
4. Click the Edit selected reader
button.
5. Click the Fingerprint settings button.
6. Edit the necessary fields. See
10.6: Fingerprint Settings
7. Click the Accept settings button.
Table 10.6: Fingerprint Settings Fields
Field Req'd?
Secondary Finger Yes
Mode
Auto Resume Yes
Timeout
LED Control Yes
Beeper Control Yes
Reader Model Yes
Table
Fields.
Figure 10.7: Fingerprint Settings Screen
Description
• Disabled: reader collects only one finger for each user.
• Alternate finger: Scan of second finger grants access exactly as the first does. If user cannot
verify with one finger, the other enrolled finger can be used.
• Duress finger: Scan of second finger grants access and triggers a duress alarm. (Accomplished
by either sending an alternate facility code or with reverse parity, depending on how your
access control panel is set up.)
• Number of seconds that reader stays in idle mode after being set into idle mode by a host
command.
• Number between 60 and 65535
• Default value is 300.
• DO NOT change this setting unless advised to by technical support
• Determines what controls the reader's LED display.
• LED controlled internally: reader controls the LED display
• LED controlled externally: access control panel control the LED display
• For more information on setting up the LED control, see the reader's manual.
• Determines what controls the reader's beeper.
• Beeper controlled internally: reader controls beeper
• Beeper controlled externally: access control panel controls beeper
• For more information on setting up the beeper control, see the manual that came with the
readers.
• Select the FingerKey model type from the drop down choices which are:
• DX-2000 - Select this if you are using a DX-2000 model FingerKey.
• DX-2100 HID Prox - Select this if you are using a DX-2100 model FingerKey using HID Prox
cards.
• DX-2200 HID iClass - Select this if you are using a DX-2200 model FingerKey with HID iClass
cards.
• DX-2400 Philips Mifare Standard - Select this if you are using a DX-2400 model FingerKey with
Mifare Standard cards and settings.
• DX-2400 Philips Mifare DESFire - Select this if you are using a DX-2400 model FingerKey with
Mifare DESFire cards and settings.
Schlage • HandNet Lite Terminal User's Guide • 29