Enabling The Site; To Enable The Site Later - Schlage PIB300 User Manual

Setting Up Sites and Readers
Enabling the
Site
If the site is not
physically set up
yet
If you have been
using readers
independently of
HandNet and you
need to get users
from the readers
If you are ready
to connect
To Enable the
Site Later
40
This is the final screen that you see in the New Site Wizard (when you go back
to Site Properties to change this site, this is on the General tab).
Enable Site: You must enable the site before HandNet can communicate with
the readers in it, but you might not want to enable it yet. Please read the
sections below if you are not sure.
If the site is not physically set up yet, do not enable it; you do not want HandNet
to repeatedly try to communicate with something that is not there. This would
slow the system down.
If you have been using readers independently of HandNet and if you want to get
the users from the readers into HandNet, you also do NOT want to enable the
site until you have set HandNet to accept users from the reader that are
not in HandNet. To do this:
1. Click Finish without checking the Enable Site box.
2. Pick Settings from the View menu.
3. Click the Security tab.
4. Check the box by Do not delete unauthorized enrollments (see page 23
for more about what this option does; after you have gotten users from
the reader, you may want to check this box again).
If you enable both the site and the reader without changing this setting,
HandNet will regard all of the users in the reader as unauthorized (because they
are not in HandNet yet) and it will delete them from the reader. Once it deletes
them, there is no way to get them back without adding and enrolling the users
again.
If the site is physically set up and you do not need to get users from the readers
(or if you have already changed the setting above), then you can enable the site
now. Check the Enable Site box and then click Finish.
After you leave this screen, you can enable the site by doing this:
1. Open the Network window.
2. Double-click the site in the left pane of the window to open up the site
properties (or click once and pick Properties from the Site menu).
3. Check the Enabled box and then click OK.
* * * * *