Schlage PIB300 User Manual page 1007

Hide thumbs Also See for PIB300:

Table of Contents

Enter Command Menu

ENTER PASSWORD

4. Press the default password for the menu you wish to enter.

for the Service Menu.

for the Setup Menu.

for the Management Menu.

for the Enrollment Menu.

for the Security Menu.

6. If you are authorized to use this command the first command option in the selected

menu appears.

7. If you are not authorized to enter this command the display appears as follows.

To access these menus you must be the first person enrolled in a new system installation

or you must have been enrolled as a supervisor. If you are blocked from the supervisory

menus, verify your access rights with management personnel. If enrollment information

has been incorrectly changed and you must have supervisory access to all menus, make

these changes through software.

It is possible to physically reset the HandPunch's memory, however resetting memory

sets all unit parameters back to the factory default values. Resetting memory allows

access to all menus by the first person enrolled (as if it is a new system installation), but

this means that all employee information programmed into the HandPunch is lost and

must be re-entered manually. Be sure you need to reset memory before performing this

function. To reset memory, refer to the Erasing HandPunch Memory section on page 19.

Show Quick Links

Chapters

Table of Contents