Appendix C - Old Board Configuration
Appendix C
Old Board Configuration Information
Wall Plate Installation
1. Loosen the three bottom mounting screws until there is approximately 1/8
2. Remove the HandPunch from its carton.
3. At the base of the HandPunch is a piano hinge with three keyhole shaped
Figure 13-1: Attaching the HandPunch to the Wall Plate
4. Tighten all three lower mounting screws.
5. The HandPunch is now ready for its wiring connections.
76
inch (3 mm) clearance between the screw head and the wall plate.
slots that correspond with the three lower mounting screws. Align and
hang the HandPunch from the three lower mounting screws (see below).
2 UPPER SCREWS
3 LOWER
MOUNTING
SCREWS
HOLE
SURFACE
CONDUIT
ENTRY
KEYHOLE
HOLES
REAR OF TERMINAL