Schlage PIB300 User Manual page 1170

Adding and Maintaining Users
88
3. Type your user ID number (the same one you enter to get access through
the reader), and press ENTER or #. The reader asks you to place your
hand. Once it recognizes your hand, this display looks like this:
ENTER PASSWORD
4. Type 4 and press ENTER or # (this is the standard password for the
Enrollment menu in the reader; if you have changed this on the Passwords
screen in the Reader Properties, enter the password you have set up).
If you have a HandKey II or HandKey CR reader: The display should
now look like this:
If you have an ID3D HandKey reader: The display should now look like
this:
If the reader shows the READY screen again instead of this screen, then
either you placed your hand improperly or you do not have the rights to do
this; carefully check step one again.
5. Press the YES / # button. This display should now look like this:
6. Type the ID number of the user to enroll and press ENTER or YES / #. The
display should now look like this:
7. Have the user place his/her hand on the reader. The reader will ask the user
to remove the hand and place it again. The reader should ask the user to
place his/her hand three times; if it asks for the hand more than three times,
the user is not placing his/her hand consistently; go over the instructions for
correct hand placement.
Once the user has correctly placed the hand three times, the reader asks
for the time zone:
ADD USER
* NO YES #
ENROLL USER
* NO YES #
ID?
:
** PLACE HAND **
1/3
ENTER TIME ZONE
(0)?: