Schlage PIB300 User Manual page 354

Service Menu
Calibrate
Status Display
Network Status
!
NOTE
38
The Calibrate command verify that the HandReader's exposure values are within normal
operating parameters. The normal operating parameters are shown in Table 7.
Table 11-7: Normal Operating Parameters
Parameter
Row "r"
Column "c"
Exposure
The status display command allows you to enable or disable the displaying of the
following information.
• the status values of HandReader inputs and outputs
• the hand read score of the last user to verify on the HandReader
Figure 9-1 identifies each status display field value.
-
O C O C O H L H L NN
O = Circuit Open
C = Circuit Closed
The network status command allows you to check the network communication status of
the HandReaders in the HandKey system.
You can check network status only from the Master HandReader in a master/remote
HandReader network.
Network status is displayed by reader address, 16 units at a time.
Each "O" and "." represents a HandReader address in the network. An "O" indicates that
the HandReader corresponding to that address is communicating on the network. A "."
indicates that the HandReader with that address is not communicating on the network.
Normal Range
0 +/- 2
0 +/- 2
100 +/- 20
ENTER ID -
Last Hand Read Score
Aux Out 2
Aux Out 1
* Aux Out 0
* Lock
Aux In 2
Request to Exit
Aux In 1
Door Monitor Switch
Tamper
H = Output is OFF (High)
L = Output is ON (Low)
STAT: RDR 0-15
O O O O O O O O. . . . . . . .
* These status values are
inactive if the reader is in Card
Reader Output Mode.
Figure 11-1: Status Display Chart