Rip Commands - 3Com 9000 SX User Manual

RIP Commands

Table 4-17 RIP Commands
Command
show rip {vlan <name> | all}
enable rip
disable rip
config rip add {vlan <name> | all}
config rip delete {vlan <name> | all}
enable rip aggregation
disable rip aggregation
enable rip splithorizon
disable rip splithorizon
enable rip poisonreverse
disable rip poisonreverse
enable rip triggerupdate
disable rip triggerupdate
(continued)
Table 4-17 describes the commands used to configure the RIP protocol.
Description
Displays RIP configuration and statistics for one or more
VLANs. Display includes the state for RIP settings, and
interface states. Statistics include the following:
Packets transmitted
Packets received
Bad packets received
Bad routes received
Number of RIP peers
Peer information
Allows you to enable RIP.
Allows you to disable RIP.
Allows you to configure RIP on an IP interface. If no
VLAN is specified, then "all" is assumed. When an IP
interface is created, per interface RIP configuration is
enabled by default.
Allows you to disable RIP on an IP interface. When RIP
is disabled on the interface, the parameters are not
reset to their defaults.
Allows you to enable RIP aggregation of subnet
information on a RIP version 2 interface. The default
setting is enabled.
Allows you to disable the RIP aggregation of subnet
information on a RIP version 2 interface.
Allows you to enable the split horizon algorithm for
RIP. Default setting is enabled.
Allows you to disable split horizon.
Allows you to enable the split horizon with
poison-reverse algorithm for RIP. The default setting is
enabled.
Allows you to disable poison reverse.
Allows you to enable triggered updates. Triggered
updates are a mechanism for immediately notifying a
router's neighbors when the router adds or deletes
routes, or changes the metric of a route. The default
setting is enabled.
Allows you to disable triggered updates.
Port Commands 4-19