Configuring Igmp - Enterasys Matrix 2G4072-52 Configuration Manual

10.4.2 Configuring IGMP

Purpose
To display and set IGMP configuration parameters, including query interval and response time
settings, and to create and configure static IGMP entries.
Commands
The commands used to configure IGMP are listed below and described in the associated sections as
shown.
•
show igmp query
•
set igmp query-enable
•
set igmp query-disable
•
show igmp grp-full-action
•
set igmp grp-full-action
•
show igmp config
•
set igmp config (Section
•
set igmp delete (Section
•
show igmp groups
•
show igmp static
•
set igmp add-static
•
set igmp remove-static
•
show igmp protocols
•
set igmp protocols
•
clear igmp protocols
•
show igmp vlan(Section
•
show igmp reporters(Section
•
show igmp flow(Section
•
show igmp counters(Section
•
set igmp number-groups
•
show igmp number-groups
(Section 10.4.2.1)
(Section 10.4.2.2)
(Section 10.4.2.3)
(Section 10.4.2.4)
(Section 10.4.2.5)
(Section 10.4.2.6)
10.4.2.7)
10.4.2.8)
(Section 10.4.2.9)
(Section 10.4.2.10)
(Section 10.4.2.11)
(Section 10.4.2.12)
(Section 10.4.2.13)
(Section 10.4.2.14)
(Section 10.4.2.15)
10.4.2.16)
10.4.2.17)
10.4.2.18)
10.4.2.19)
(Section 10.4.2.20)
(Section 10.4.2.21)
Matrix DFE-Platinum and Diamond Series Configuration Guide
IGMP Configuration Command Set
Configuring IGMP
10-7