To Perform Self Test - Keysight M9614A Startup Manual

Pxie 5-channel precision source/measure unit (smu)

Hide thumbs Also See for M9614A:

Table of Contents

To Perform Self Test

You can perform the self test by using the M960x PXIe Source Measure Unit Soft

Front Panel (the M960x SFP).

Before performing the self test, turn the instrument output off and disconnect

cables from the measurement terminals.

1. Click Start menu > Keysight M960x Source Measure Unit > M960x SFP. The

2. In the list on the window, highlight the M9614A/M9615A modules to connect,

3. Confirm that the Access indicator on the M9614A/M9615A front panel turns

4. Select Self Test... from the Utilities menu. The Self Test dialog box will open.

5. Click Run Self Test at the bottom of the Self Test dialog box to start the self

If the module fails the self test, it will be defective. See

Service" on page 10

Use the module within the rating. If you input a signal above the rating, the

module will be damaged.

Keysight M9614A/M9615A Startup Guide, Edition 1

Connect to Instrument dialog box will open.

and click Connect to launch the M960x SFP.

green. Refer to

Figure 1-1

test. When the self test is completed, the results will be displayed in the Self

Test dialog box.

to return the modules to Keysight.

Step 5: Verify Operation of the Module

and

Table 1-3

for LED status.

"Return the Module for

Table of Contents

M9615a