Sweep Dialog Box; Input Connection Dialog Box - Keysight B2980B Series User Manual

Front Panel Reference
Config Key Group
Resistive Limit State

Sweep Dialog Box

(B2985B/B2987B) This dialog box provides the following parameters for setting
details of the sweep source operation.
Sweep Ranging
Sweep Direction Sweep direction, UP (start to stop direction) or DOWN (stop to
Output after
Sweep
Table 4-7
BEST
FIXED

Input Connection Dialog Box

(B2985B/B2987B) This dialog box provides the following parameters for setting
the measurement operation and connection.
174
Ranging mode used for the sweep source operation, BEST or
FIXED. See
start direction)
The value the source channel applies after it completes the
sweep output
START VALUE (START): The source channel changes the output
to the DC output value just before applying the sweep output
start value.
END VALUE (END): The source channel keeps the output value
when the sweep output is stopped.
Ranging Mode used for Sweep Source Operation
The sweep source channel automatically uses the minimum range which covers the
whole sweep output.
The sweep source channel sets the range specified by the range parameter Spot
Source Range. See
This is the source setup condition after
output off. See
Voltage source output resistor (20 M)
connection, ON (serial connection) or OFF
(no connection)
Table 4-7 on page
Description
"Range Setup Sub-panel" on page
Keysight B2980B User's Guide, Edition 1
Table 5-2 on page
174.
151.
220.