Settings Conflict; Db*/Mhz Is Not Applicable To The Following Y-Axis Units, Dbm, W, V, A - Keysight X-Series Manual

Instrument Messages
Event Messages
Err# Message
-221
Settings conflict;
dB*/MHz is not applicable
to the following Y-Axis
units, dBm, W, V, A
-221
Settings conflict;
De-emphasis is only
available when Modulation
Mode is FM
-221
Settings conflict;
Destination trace for
Trace Math cannot be a
trace operand
-221
Settings conflict;
Differential setting
determined by probe type
-221
Settings conflict;
Display unit control not
available when in
Relative measurement
-221
Settings conflict;
Downconv only available
when DUT is Amplifier
-221
Settings conflict; DUT
Expected Power cannot be
greater than Peak Power,
Acq=# Step=#
-221
Settings conflict; EDGE
EVM only supports EDGE TCH
burst type.
-221
Settings conflict;
Electronic attenuator is
disabled
-221
Settings conflict;
Electronic attenuator is
not available above
3.6 GHz
-221
Settings conflict;
Electronic attenuator
unavailable in current
state
Instrument Messages
Verbose/Correction Information
You cannot turn on dB*/MHz for Y-Axis units: dBm, W, V, A. It is
not applicable to these units.
You are not allowed to change the De-emphasis value in AM and
PM Modulation Mode.
The resulting trace data (from doing a trace math function) cannot
be put into the any of the traces that are being used by the math
operation.
A probe is connected that has a built in Differential setting. The
setting cannot be changed manually.
You are not allowed to change the display settings. The result is
currently displayed in relative value, which reference to the power
level when Set Ref action. To change the display settings, switch
the Measurement Mode to Absolute.
SCPI only message. The System Downconverter can only be set to
'On' when the DUT type is amplifier. Change DUT type to Amplifier
if the System Downconverter is required.
Changing Peak Power will cause DUT Expected Power to be
clipped.
You are using the mechanical attenuator, and have not enabled
the electronic attenuator. You cannot set the value of the
electronic attenuator because it automatically sets/changes when
enabled.
The maximum frequency of the electronic attenuator is 3.6 GHz.
This is because of switching capacitance.
52