10.2 Odu Remote Control Address Setup - Comtech EF Data CDM-425 Installation And Operation Manual

10.2 ODU Remote Control Address Setup

•
•
The ODU, as connected to a CDM-425 through FSK (Frequency Shift Keying), can be remotely
monitored and controlled through the use of ODU commands and queries issued via serial
remote control or with the Telnet Command Line Interface (CLI).
The address of the ODU is set up as follows:
•
For Local-End ODUs:
o
o
•
For Distant-End ODUs in an EDMAC setup:
o
o
ODU (Transceiver, BUC, LNB) Operation
Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT
Appendix H. EDMAC CHANNEL
Use the Modem's RC Address + 1 for a Standalone Unit or the Online Unit in a
1:1 Redundancy System;
Use the Modem's RC Address + 2 for the Offline Unit in a 1:1 Redundancy
System.
Use the EDMAC Slave Address (ESA) Range +4 for Standalone Unit or the
Online Unit in a 1:1 Redundancy System;
Use the EDMAC Slave Address (ESA) Range +5 for the Offline Unit in a 1:1
Redundancy System.
CDM-425 Advanced Satellite Modem
10–2
Revision 0
MN-CDM-425