Comtech EF Data CDM-425 Installation And Operation Manual page 352

Advanced satellite modem (18 kbps – 25 mbps)
Table of Contents

Advertisement

Command
Length of
Parameter
(Instruction
Arguments
& Qualifier)
Retrieve next
N/A
80 bytes
five unread
Stored Events
Clear All
CAE=
None
Stored Events
Initialize
IEP=
None
Stored Events
Pointer
Statistics
SSI=
1 byte,
Sample
numerical
Interval
Number of
N/A
3 bytes
Unread stored
Statistics
Serial Remote Control
Description of Arguments
Query only.
Returns the oldest five stored events that have not yet been read over remote control in the form
[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body. Sub-body=ABCddmmyyhhmmss,
where:
A=fault/clear indicator, where:
F=Fault
C=Clear
I=Info
B=fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Info (Power on/off, or log cleared)
5=Reserved
6=BUC
7=LNB
C=Fault Code number, as in FLT? or Info Code, which may be:
0=Power Off
1=Power On
2=Log Cleared
3=Global Config Change
4=Redundancy Config Change
5=Fractional CnC License is expiring.
6=Time Limited CnC License is expiring.
7=Fractional CnC is in use.
ddmmyy=date stamp
hhmmss=time stamp
NOTES:
1) If there are less than five retrievable events, the remaining positions are padded with zeros.
2) If there are no new events, the response is RNE*.
Command only.
This command takes no arguments. Forces the modem to clear the firmware events log.
EXAMPLE: <0/CAE=
Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log.
Command or Query.
Sets or returns the sample interval for the Statistics Logging Function in the form x, where:
x=0 thru 9 in 10 minute steps.
NOTE: Set this parameter to 0 thru disable the statistics logging function.
EXAMPLE: <0/SSI=3 (interval is set at 30 minutes)
Query only.
Returns the number of stored statistics that remain unread over remote control, in the form xxx, where:
xxx=000-255.
EXAMPLE: <0/NUS? >0/NUS=187
8–28
CDM-425 Advanced Satellite Modem
Revision 0
Query
Response to
(Instruction
Response to Query
Command
& Qualifier)
N/A
RNE?
RNE=[CR]ABCddmm
yyhhmmss[CR]ABCd
dmmyyhhmmss[CR]A
BCddmmyyhhmmss[
CR]ABCddmmyyhhm
mss[CR]ABCddmmyy
hhmmss
(see Description of
Arguments)
CAE=
N/A
N/A
CAE?
CAE*
CAE#
IEP=
N/A
N/A
IEP#
SSI=
SSI?
SSI=x
SSI?
(see Description of
SSI*
Arguments)
SSI#
N/A
NUS?
NUS=xxx
(see Description of
Arguments)
MN-CDM-425

Advertisement

Table of Contents
loading

Table of Contents