6.2.1.11.7 CONFIG: Mask BUC
Chapter 10. OUTDOOR UNIT (ODU) (TRANSCEIVER, BUC, AND LNB)
OPERATION
BUC alarm = Active
Attach to Tx alarm = No
When L-Band is in use, you may include a BUC in the operating system. You may monitor and
control a 'smart' BUC via the modem using FSK. For a modem in a 1:1 redundancy setup, you
must customize the fault indications for the physical setup.
6.2.1.11.8 CONFIG: Mask LNB
Chapter 10. OUTDOOR UNIT (ODU) (TRANSCEIVER, BUC, AND LNB)
OPERATION
LNB alarm = Active
Attach to Rx alarm = No
When L-Band is in use, you may include a Low-Noise Block Down Converter (LNB) in the
operating system. You can use the modem only to monitor and control the power supply values.
For a modem in a 1:1 redundancy setup, you must customize the fault indications for the physical
setup.
6.2.1.11.9 CONFIG: Mask ClkExt (G.703 Clock Extension Mask)
G.703 Clock Extension = Active
(Active, Masked)
Use the ▲▼ arrow keys to select Active or Masked. Press ENTER.
When you select Active, the modem generates a ClkExt (Clock Extension) alarm if the G.703
Clock Extension mode is set to TxLock and the input is lost or removed from the G.703 interface.
Front Panel Operation
CDM-425 Advanced Satellite Modem
(Active,Mask)
(Yes,No)()
(Active,Mask)
(Yes,No)()
6–51
Revision 0
()
MN-CDM-425
Need help?
Do you have a question about the CDM-425 and is the answer not in the manual?
Questions and answers