Comtech EF Data CDM-425 Installation And Operation Manual page 360

Command
Length of
Parameter (Instruction
Arguments
& Qualifier)
ACM ACM= 4 bytes
parameters
Forced FRB= None
Reboot
Carrier ID CAI= 1 byte,
State 0 or 1
Demo Time N/A 6 bytes,
Remaining numeric
Demo Mode DMM= 1 byte,
0 thru 2
Medium-Earth MEO= 1 byte,
Orbit 0 or 1
Antenna AHO= 1 byte,
Handover 0 or 1
Antenna AHM= 1 byte,
Handover 0 or 1
Mode
Serial Remote Control
Description of Arguments
Command or Query. (Only applicable in VersaFEC ACM and VersaFEC-2 ACM mode.)
Sets or returns ACM operating parameters in the form mMAT, where:
In VersaFEC ACM (IP-ACM):
m=Minimum Tx ModCod, range is 0 thru 9, and A (for ModCod=10) or B (for ModeCod=11)
M=Maximum Tx ModCod, range is 0 thru 9, and A (for ModCod=10) or B (for ModeCod=11)
A=Action on remote demod unlock (0=go to minimum Tx ModCod, 1=maintain Tx ModCod)
T=Target Eb/No Margin, from 0 thru 9 that is two times of the Eb/No in dB (from 0.0dB to 4.5dB).
In VersaFEC-2 ACM (V2-ACM):
mM=Maximum Tx ModCod in decimal, range is 00-37 for Long Block, and 00-35 for Short Block.
A=Action on remote demod unlock (0=go to Tx ModCod 0)
T=Target Eb/No Margin, from 0 thru 9 that is two times of the Eb/No in dB (from 0.0dB to 4.5dB).
EXAMPLE: <0/ACM=3702. (Set max ModCod=37. Go to Tx ModCod when remote demod unlocks, sets
Target Eb/No at 1.0dB.)
Command only.
This command takes no arguments. Forces a hard reset of the unit after 5 seconds.
Command or Query.
Sets or returns Carrier ID On/Off State in the form x, where:
0=Off
1=On
Query only.
Returns remaining Demo time in the form ddhhmm, where:
dd=days (00 thru 30)
hh=hours (00 thru 23)
mm=minutes (00 thru 59)
EXAMPLE: <0/DMT? >0/DMT=032312 (3 days 23 hours 12 minutes)
Command or Query.
Sets or returns Demo Mode function in the form x, where:
0=Disabled
1=Enabled
2=Expired
Command or Query.
Sets or returns Medium Earth Orbit function in the form x, where:
0=Disabled
1=Enabled
Command or Query.
Sets or returns Antenna Handover function in the form x, where:
0=Disabled
1=Enabled
Command or Query.
Sets or returns Antenna Handover Mode in the form x, where:
0=Manual
1=Auto
8–36
CDM-425 Advanced Satellite Modem
Revision 0
Query
Response to
(Instruction Response to Query
Command
& Qualifier)
ACM= ACM? ACM=mMAT
ACM? (see Description of
ACM# Arguments)
FRB= N/A N/A
FRB?
FRB*
FRB#
CAI= CAI? CAI =x
CAI? (see Description of
CAI * Arguments)
CAI #
N/A DMT? DMT=ddhhmm
(see Description of
Arguments)
DMM= DMM? DMM=x
DMM? (see Description of
DMM* Arguments)
DMM#
MEO= MEO? MEO=x
MEO? (see Description
MEO* of Arguments)
MEO#
AHO= AHO? AHO=x
AHO? (see Description of
AHO# Arguments)
AHM= AHM? AHM=x
AHM? (see Description of
AHM# Arguments)
MN-CDM-425