6.2.1.13.3 Config: Ip  Setup - Comtech EF Data CDM-425 Installation And Operation Manual

6.2.1.13.3 CONFIG: IP  Setup
IP Setup: Mode
MAC-Lrng Rad VLAN QoS Stats FrmSize ()
Use the ◄ ►arrow keys to select a parameter. Press ENTER.
6.2.1.13.3.1 CONFIG: IP  IP Setup: Mode
Working Mode: Router Point to Point
(ManagedSwitch,R-PtoP, R-MPHub,R-MPRm)()
Use the ◄ ►arrow keys to select ManagedSwitch, R-PtoP (Router Point-to-Point), R-MPHub
(Router Multipoint-to-Hub), or R-MPRm (Router Multipoint-to-Remote). Press ENTER.
If the optional IP Packet Processor card is either not installed or installed but
disabled, the mode is "Fixed at Managed Switch Mode".
6.2.1.13.3.2 CONFIG: IP  IP Setup: WAN
WAN:
Avg Buffer Fill State = 00%
On the top line – Use the ▲▼ arrow keys to edit the WAN Buffer Length. Press ENTER. Valid
settings are:
Minimum
20ms
Press ENTER. Packets are dropped when the buffer is exceeded.
On the bottom line (read-only) – The percentage of the Average WAN Buffer Fill State displays
across a 4-second duration.
When you install and enable the optional IP Packet Processor card, the WAN
submenu is non-functional and displays as follows:
WAN:
Avg Buffer Fill State = xx%
Front Panel Operation
WAN PerPortCnfg DDMgmtPt
Buffer Length = 240ms
Maximum
400ms
Buffer Length = N/A due to PktP
6–56
CDM-425 Advanced Satellite Modem
()
Step Size (Increment)
20ms
()
MN-CDM-425
Revision 0