Table of Contents
Advertisement
Use the Front Panel keypad. Use the ◄ ►arrow keys to access the nested 'Ethernet IP
•
Address/Range' screen (SELECT: Configuration ►IP ►Addresses ►Addr/Range)
SELECT: Configuration
Info
CONFIG:
CnC
IP Config: Addresses
Ethernet IP Address/Range:
To configure the Target Modem Traffic/Management IP Address, use the ◄ ►arrow
keys to select a digit to edit, and then the ▲▼ arrow keys to change that digit. Press
ENTER when done.
•
Use Serial Remote Control. Type the "<0/IPA=XXX.XXX.XXX.XXX.XX{CR}" remote
command without quotes at the Serial Interface command prompt (where
xxx.xxx.xxx.xxx is the Target Modem Traffic/Management IP Address) to configure. You
may issue the remote query (<0/IPA? {CR}{LF}) to report back the result:
The CDM-425 Advanced Satellite Modem Target Modem is now configured to operate identically
to the CDM-425 Advanced Satellite Modem Source Modem. The FTP Modem-to-Modem
Configuration procedure is now complete.
Appendix P
Store/Ld
Utility
All
Mode
EDMAC
Misc
ANT
AccessList
192.168.001.091/24
The IP Address that appears here is provided as an example only. Make
sure that you re-use the Traffic/Management IP Address that was
assigned to the Target Modem prior to reconfiguration.
>0/IPA=192.168.001.091.24 (example)
CDM-425 Advanced Satellite Modem
Test
Monitor
ODU
FAST
Tx
Rx
Clocks D&I/ACM
Mask
Remote
IP
SNMP
Setup
PktP-Enable
P–5
Revision 0
()
()
()
()
MN-CDM-425
Advertisement
Table of Contents
