Comtech EF Data CDM-425 Installation And Operation Manual page 133

However, with CONFIG: Mode set to IP-ACM or V2-ACM mode, the bottom line appears as
follows:
Output Power Mode=AUPC
Mode/Range
Use the ◄ ►arrow keys to select Target-EbNo-Range or Mode/range (when in IP-ACM or
V2-ACM mode), or Alarm Action. Press ENTER.
CONFIG: Tx  Power  Mode  AUPC  Target-EbNo-Range
Minimum EbNo of Remote Modem = 4.0dB
Max Permitted Power Increase = 3dB ()
On the top line – Edit the Target Eb/No of the remote modem by using the ◄ ►arrow keys to
select a digit. Then, use the ▲▼ arrow keys to change that digit. Press ENTER. Valid settings
are:
Upper Limit
14.9 dB
On the bottom line – Edit the maximum permitted increase in power level when in AUPC Mode by
using the ◄ ►arrow keys to select a digit. Then, use the ▲▼ arrow keys to change that digit.
Press ENTER. Valid settings are:
Upper Limit
9 dB
CONFIG: Tx  Power  Mode  AUPC  Alarm-Action
Tx-Alarm:None
Rem Dmod Unlock Act=NomPwr(Nom,Max,Hold)
On the top line – Configure the action that occurs if the AUPC causes the maximum output power
level to be reached. Use the ▲▼ arrow keys to select None or Tx Alarm. Press ENTER.
On the bottom line – Configure the action that occurs if the remote demod is unlocked. Use the
▲▼ arrow keys to select Nom-Pwr or Max-Pwr. Press ENTER.
Front Panel Operation
(Manual,AUPC)
Alarm-Action
Upper Limit When CnC is ON
6 dB
(MaxPwr,MinMCod,None)
6–15
CDM-425 Advanced Satellite Modem
()
Default
3.0 dB
Default
3 dB
Revision 0
MN-CDM-425