Comtech EF Data CDM-425 Installation And Operation Manual page 110

g. Press the front panel CLEAR key as prompted.
h. Type "bye" to terminate the FTP session, and then close the Command-line
5. Use the modem front panel menus, the modem HTTP Interface 'Admin | Firmware |
Packet Processor' page, or issue the Serial Remote Interface <0/SWR? or <0/FRW?
query as shown previously, to verify that the PC-to-Modem IP Packet Processor firmware
FTP file transfer was successful.
6. Use the modem front panel menus, or the modem HTTP Interface 'Admin | Firmware |
Base Modem' or, as needed, 'Admin | Firmware | Packet Processor' page to select the
desired firmware image to boot from:
a. Using the modem front panel menus:
b. Using the modem HTTP Interface
Updating Firmware
window.
i. First, to select the desired Boot Image, make sure that you are operating
in LOCAL mode (CONFIG: Remote  Local).
ii. Then, go to the SELECT: Utilities  Firmware  Base-modem 
Select menu branch and use the ▲▼ arrow keys to select the Next
Reboot Image as 1 or 2.
iii. Press ENTER when done.
i. Typical for either 'Admin | Firmware' page, use the drop-down list to
select Image#1 or Image#2.
ii. Click [Submit] to save.
CDM-425 Advanced Satellite Modem
4–14
Revision 0
MN-CDM-425