Table of Contents
Advertisement
E.9
RX Buffer Clock = Insert (D&I only)
The E1 or T1 clock recovery from the IDI G.703 port serves as the RX Buffer reference. In
addition, the recovered data is the E1/T1 input to the Insert Mux. If the RX G.703 recovery circuit
detects no activity at IDI input, or cannot detect the expected frame format, Buffer Clock = RX
Satellite will be chosen as a fall-back.
If 'Insert' is not the selected buffer clock reference, the clock and data from the IDI port is ignored,
and a new E1/T1 frame is generated. The timeslots coming from the satellite are then re-inserted
into the selected timeslots of this new blank frame, and output on the IDO port.
E.10 Single-Source Multiple Modems
Two ways to connect a single T1 or E1 stream to several modems are by looming or daisy-chaining
modems. Looming method is illustrated in Figure E-5, while Figure E-6 illustrates the daisy-chain
method – each requires the RX Buffer Clock = Insert setting. Note the following:
•
Assign all timeslots to not overlap.
•
Assign modems to number of TX/RX channels as required.
MODEM
DDI
DDO
Terrestrial Trunk
Appendix E
Figure E-5. Single-Source Multiple Modems (Looming)
MODEM
IDI
IDI
IDO
Multiple Modem Drop & Insert Application: This application shows how the loop is extended
to one or more additional modems.
DDO- IDI connection may be made internally using Loop = Y under D&I menu.
Figure E-6. Single-Source Multiple Modems (Daisy-chain)
CDM-425 Advanced Satellite Modem
MODEM
E–10
Revision 0
MN-CDM-425
Advertisement
Table of Contents
