Multicast Routing Configuration - Comtech EF Data CDM-425 Installation And Operation Manual

I.4.2.1

Multicast Routing Configuration

Chapter 7. ETHERNET-BASED PRODUCT MANAGEMENT
To configure a Multicast Routing Network (Figure I-12):
•
For "Hub Outbound" Modem Configuration – Refer to Chapter 7. ETHERNET-
BASED PRODUCT MANAGEMENT, Sect. 7.5.4.3.3.1 Configuration | Routing |
Routes. Add a multicast route (using the page's Add New Route section), making sure
to select toWAN from the Interf. drop-down menu (this defines the route as LAN 
WAN). Click [Add Entry] once the route is created.
•
For "Remote" Modem Configuration – Refer to Chapter 7. ETHERNET-BASED
PRODUCT MANAGEMENT, Sect. 7.5.4.3.3.2 Configuration | Routing | IGMP. From
the page's IGMP Multicast Router section, edit the IGMP parameters to suit the
multicast receivers' capabilities (i.e., version number and query intervals).
Appendix I
Figure I-12. Multicast Routing Network Configuration Example
CDM-425 Advanced Satellite Modem
I–13
Revision 0
MN-CDM-425