Table of Contents
Advertisement
o
o
•
Packet Processor: This feature is operational only when the optional IP Packet
Processor card is installed. Use the drop-down list to select the IP Packet Processor card
as Enabled or Disabled.
Click [Submit] to save.
Per Port Configuration
Set the parameters on a per-port basis (Port 1 through Port 4). Note the following:
Column
Speed
Pause Flow Control
Port Mode
PVID
Priority
Actual Negotiated
Port Speed
Click [Submit Port Cnfg] to save.
Ethernet-based Remote Product Management
Router Multipoint Hub: Functions as the Hub side router in a Point-to-Multipoint
network. Allows Satellite-to-Satellite packets to pass.
Router Multipoint Remote: Functions as a Remote Router in a Point-to-
Multipoint network. Packets from the WAN are not allowed to be sent to the
WAN.
When you change the optional IP Packet Processor card operation (i.e.,
Enabled or Disabled), after you click the [Submit] tab the modem is forced
to reboot and you will see the following message:
Note that, before clicking [OK] to proceed with reboot of the modem, you
may first need to clear the PC's ARP table.
Use the drop-down list to select the speed for each selected port: Auto, 100 Full, 100 Half,
10 Full, or 10 Half.
Use the drop-down list to select Pause Flow Control for the port as Off or On.
Use the drop-down list to select Port Mode for the port as Access or Trunk.
When Port Mode is Access, a PVID (Native VLAN ID) may be assigned to the selected
port using a value range of 0001-4095. (See note about PVIDs (Native VLAN IDs) vs.
Management VLAN IDs.)
Use the drop-down list to set the operational priority of the selected port, in the order of
preference (from 1 to 4).
This is the status of the current operating actual speed and duplex. If the port is not
connected, and then "Link Down" is displayed.
CDM-425 Advanced Satellite Modem
Description
7–36
Revision 0
MN-CDM-425
Advertisement
Table of Contents
