Comtech EF Data CDM-425 Installation And Operation Manual page 631

5. Go back to the SELECT: CONFIG CnC  MODE menu. On the bottom line, which will
be displaying Activate? N (Y,N), use the ▲▼ arrow keys to select Y(Yes)and then
press ENTER.
The modem display will update, similar to the following example:
The CnC Mode: APC,Side 'A',C-Band (Off,On,APC)
Suspend?
The message on the bottom line can be any one of the following:
Displayed Message
OK-ReBalance Done
OK(P)CnCRatio Lim
OK(P)-LocalPwr Min
OK(P)-LocalPwr Max
OK(P)-LocalPwr Lim
OK(P)-DistPwr Min
OK(P)-DistPwr Max
OK(P)-DistPwr Lim
OK(P)-Incomplete
No APC Frame Sync
Locl EbNo too high
Dist EbNo too high
DistEnd ReBal fail
DistEnd NoResponse
Appendix F
N (Y,N) OK-ReBalance Done
Full re-balance was achieved
Partial re-balance, limited by CnC ratio approaching its working limit
Partial re-balance, limited by local power approaching its lower limit
Partial re-balance, limited by local power approaching its upper limit
Partial re-balance, limited by local power approaching TPLI
Partial re-balance, limited by distant power approaching its lower
limit
Partial re-balance, limited by distant power approaching its upper
limit
Partial re-balance, limited by local power approaching TPLI
Partial re-balance, algorithm did not fully converge
Communication not possible – no APC frame sync
The local Eb/No is too high (>16 dB) to determine re-balance params
The distant Eb/No is too high (>16 dB) to determine re-balance
params
The distant end failed to re-balance
The distant end failed to respond
F–29
CDM-425 Advanced Satellite Modem
()
Expanded Meaning
Revision 0
max
max
MN-CDM-425