6.2.1.13.3.3 CONFIG: IP Setup: PerPortCnfg
Per-Port-Config:
Port1
Use the ◄ ►arrow keys to select Port1 through Port4. Press ENTER.
CONFIG: IP IP Setup: PerPortCnfg Port#
Where # denotes the selected Port:
Port#:
Speed=Auto
On the top line – Set Pause Frame Flow Control on a per port basis. Use the ▲▼ arrow keys to
set this control as On or Off (default is Off). To turn Pause on for the active (selected) port, you
must meet the following conditions:
•
Tx Data Rate or IP Info Rate (if Sub-Mux is on), or a data rate calculated based on
ModCod00 from the Symbol Rate in ACM, must be at least 128 kbps, and
•
WAN Buffer Length (see the important WAN Buffer Notes that follow).
This menu displays actual negotiated speed (NegoSpeed:) as a read-only status item.
On the bottom line – Use the ▲▼ arrow keys to select the desired speed setting. Valid settings
are:
Setting
Sets the port speed as Auto Negotiated. This allows the ports to negotiate speed and half/duplex
Auto
operation.
100Full
Forces the Port to 100/Full.
100Half
Forces the Port to 100/Half.
10Full
Forces the Port to 10/Full.
10Half
Forces the port to 10/Half.
Front Panel Operation
Port2
Port3
Pause=Off
(Auto,100F/H,10F/H)
6–57
CDM-425 Advanced Satellite Modem
Port4
()
NegoSpeed:LinkDwn
()
Function
Revision 0
MN-CDM-425