Table of Contents
Advertisement
6.2.1
SELECT: CONFIG (Configuration) Menu Branch
CONFIG: All Mode Tx
CnC
CONFIG: All Mode Tx
CnC
Use the ◄ ►arrow keys to select a submenu. Press ENTER. Valid selections are:
Submenu
All
Mode
Tx
Rx
Clocks
D&I
ACM
CnC
EDMAC
Misc
Mask
Remote
Front Panel Operation
EDMAC Misc Mask
EDMAC Misc Mask
Sect.
This submenu is highly recommended for new users, as it leads you through
6.2.1.1
the complete modem configuration process on a step-by-step basis.
6.2.1.2
Use to select Frame Type and Data Format for Tx and Rx.
(Transmit) Use to define the Tx configuration of the unit. These menu submenu
6.2.1.3
branches would be used if you wished to change, for example, just the Tx
Frequency.
(Receive) Use to define Rx configuration of the unit. These menu submenu
6.2.1.4
branches would be used if you wished to change, for example, just the Rx data
rate.
6.2.1.5
Use to select Tx-Clocking, Rx-Buffer/Clock, or External Reference.
6.2.1.6
Use to select (Quad) Drop & Insert options (NOT AVAILABLE IN ACM MODE).
(VersaFEC
Adaptive Coding and Modulation) Use to configure ACM operating
®
6.2.1.7
parameters. (AVAILABLE, IN PLACE OF D&I SUBMENU, ONLY IN ACM
MODE).
(DoubleTalk Carrier-in-Carrier) Use to select DoubleTalk Carrier-in-Carrier
6.2.1.8
(CnC) options.
6.2.1.9
Use to select EDMAC options.
6.2.1.10
(Miscellaneous) Use to select, view, or change various other parameters.
6.2.1.11
Use to activate or MASK an alarm condition.
(Remote Control) Use to define whether the unit is being controlled locally,
6.2.1.12
remotely, or via IP, and to configure the serial remote control parameters: baud
rate, I/O format, address.
CDM-425 Advanced Satellite Modem
Rx
Clocks
ACM
Remote
IP ()
Rx
Clocks
D&I
Remote
IP ()
Function
6–8
Revision 0
MN-CDM-425
Advertisement
Table of Contents
