Table of Contents
Advertisement
Submenu
IP
You may always view the front panel operations and monitor the modem over
the remote control bus (i.e., queries only); however, only one method of remote
access may control the modem at any given time:
You must be in Local Mode to make configuration parameter changes from the
front panel. Remote Mode is required when using Serial-based remote M&C.
You must be in Ethernet Mode when using Ethernet-based remote M&C over
IP.
6.2.1.1
CONFIG: All
All = Stop
(Stop, Start)
Use this menu to configure the unit on a step-by-step basis. Every available configuration menu
displays in succession.
Use the ▲▼ arrow keys to select Stop or Start. Press ENTER to execute.
Use the ◄ ►arrow keys to select, and the ▲▼ arrow keys to edit, configuration parameters as
needed.
Press ENTER to continue through all the configurations.
Press CLEAR to discontinue.
Front Panel Operation
Sect.
Use to configure various IP parameters, including IP address, gateway, MAC
6.2.1.13
addresses, VLAN, and QoS.
CDM-425 Advanced Satellite Modem
Function
6–9
Revision 0
()
MN-CDM-425
Advertisement
Table of Contents
