Config: Rx  Ebno; Config: Rx  Snr (Ip-Acm Or V2-Acm Modes Only) - Comtech EF Data CDM-425 Installation And Operation Manual

6.2.1.4.8
Receive EbNo Alarm Point = 02.0 dB
Edit the EbNo Alarm Point by using the ◄ ►arrow keys to select a digit, and then using the ▲▼
arrow keys to change that digit. The allowable range is from 00.1 to 16.0 dB. Press ENTER.
If the Rx Eb/No falls below this value and the fault is NOT masked, a receive
traffic fault will be generated.
6.2.1.4.9
Receive SNR Alarm Point = 00.1 dB
When either ACM mode is active, the CONFIG: Rx menu changes the EbNo option to SNR.
Edit the SNR Alarm Point by using the ◄ ►arrow keys to select a digit, and then using the ▲▼
arrow keys to change that digit. The allowable range is from 00.1 to 16.0 dB. Press ENTER.
If the Rx SNR falls below this value and the fault is NOT masked, a receive traffic
fault will be generated.
Front Panel Operation
CONFIG: Rx  EbNo
CONFIG: Rx  SNR (IP-ACM or V2-ACM Modes Only)
CDM-425 Advanced Satellite Modem
()
()
6–30
Revision 0
MN-CDM-425