Table of Contents
Advertisement
HTTP Login User Access Levels are further defined as follows:
Admin User
Full Access to all
web pages.
Type the User Name and Password, and then click [OK].
Once the valid User Name and Password is accepted, you will see the HTTP Interface "splash"
page (note that the Base Modem and optional IP Packet Processor Firmware Versions listed here
are subject to change). See Figure 7-3.
To properly access the HTTP Interface, set the remote control access for the unit to Ethernet
mode. If you attempt to log in to the HTTP Interface and remote control for the modem has not
been set to Ethernet mode, access is blocked and the following error message displays in the
browser window:
Click [Enable Ethernet Mode] to switch over from your current mode to Ethernet Mode.
Alternately, from the front panel, use the
to edit, the remote control configuration menu (press ENTER when done):
SELECT: Configuration Remote Remote Control=Ethernet
Ethernet-based Remote Product Management
HTTP Login User Access Level
Read/Write User
No Access to Admin or IP Packet Processor-
related web pages.
Full Access for all other web pages
◄ ►
CDM-425 Advanced Satellite Modem
No Access to Admin or IP Packet Processor-
related web pages.
View Only Access for all other web pages.
arrow keys to navigate to, and the ▲ ▼ arrow keys
7–9
Revision 0
Read Only User
MN-CDM-425
Advertisement
Table of Contents
