Table of Contents
Advertisement
Add Static ARP
This section allows you to directly add a static ARP entry. Note that the index will automatically
increment to the next available number.
Click [Add Entry] to save.
Delete Static ARP
Enter Entry Index to Delete, and then click [Delete Entry] once all changes have been made in
this section.
Flush Dynamic ARPs
Click [Flush ARP Table] to delete all dynamically learned ARP entries.
Configuration | LAN | Port Monitoring
Port monitoring allows a port's ingress and/or egress traffic to be mirrored on another port. This is
useful for link monitoring or packet capturing without interrupting live traffic.
Port Monitoring
•
Port Monitoring: Use the drop-down list to select function as Disabled or Enabled.
•
Source (Monitoring): Use the drop-down list to select Port 1, Port 2, Port 3, Port 4, or
WAN as the source port from which to direct mirror traffic.
•
Destination (Capturing): Use the drop-down list to set the port to which to direct
captured traffic – Port 1, Port 2, Port 3, or Port 4.
•
Direction: Use the drop-down list to set the traffic flow between the Source and
Destination ports as Ingress (Rx), Egress (Tx), or Both (Rx & Tx).
Click [Submit] to save changes.
Ethernet-based Remote Product Management
Figure 7-18. Configuration | LAN | Port Monitoring Page
You cannot specify the port that is currently selected as the Source
(Monitoring) port to also be the Destination (Capturing) port. For
example, if you have selected Port 1 as the Source (Monitoring) port,
and you then select Port 1 as the Destination (Capturing) port, once
you click [Submit] the modem rejects your selections and reverts back
to the previously saved and valid settings.
CDM-425 Advanced Satellite Modem
7–39
Revision 0
MN-CDM-425
Advertisement
Table of Contents
